Montigo 36DV-SH Manuel du propriétaire télécharger pdf (Page 26)

26 Installation (for qualified installers only)

Travis Industries 4040708 100-01160

Electrical Connection

! Make sure the household breaker is shut off prior to working on any electrical lines.

! The fireplace must be properly grounded in accordance with local codes (or ANSI/NFPA 70-1987)

• The electrical line must be 14 gauge, and supply 120 Volts at 60 Hz (2 Amps)

1 Follow the directions below to connect power to the fireplace.

Insert the sheathed cable from the power source through

this cable clamp. Once the wires are attached, tighten

the clamp to secure the cable.

Replace

the cover

removed

in step "a".

Attach the common (white), ground (exposed or green) wires, and hot

(black) wires from the power source to the electrical connector (included

with the fireplace). Then attach the connector to the fireplace.

Standard

Screwdriver

Remove the cover from the

fireplace junction box.

1/4" Nutdriver

Electrical

Connector

WARNING: Make sure power is

off from the power lead before

conducting any wiring.

NOTE: If using the power heat duct, you may wish

to route the wiring for it at this point. See the

instructions under "Optional Equipment".

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Pas de commentaire

Montigo 36DV-SH Manuel du propriétaire Page 26